Technical data

Page 18
Chapter 3
Configuring Check Point 12000
Appliances
The workflow for configuring Check Point 12000 Appliances is:
1. Connect the cables and power on the appliance.
2. Use the First Time Configuration Wizard to configure the appliance.
3. Add the Check Point 12000 Appliances object in SmartDashboard and install a policy.
In This Chapter
Powering On 18
Using the First Time Configuration Wizard 19
Creating the Network Object 22
Advanced Configuration 22
Powering On
To power on Check Point 12000 Appliances:
1. Connect the power cable.
2. On the back panel, turn on the Power button to start the appliance.
Note -When a power supply fails or is not connected to the outlet, an
alarm sounds continuously. If you hear the alarm, replace the faulty
power supply immediately, and connect the new unit to an A/C outlet
("Replacing Power Supplies" on page 29).