Tus neeg siv phau ntawv
H12Tool Introduction
(1)
For switching the handsettings
(2)
For checking rubber capacity
(3)
Formatchingtheremotecontrollerwithotherreceivers(thematchingmethodis
introduced below)
(4)
For checking the image returned by thecamera
(5)
Intheadvancedoptions,youcanadjustthechannels,upgradetherockerfirmware,check the
signal strength, modify the receiver serial port baud rate (password needs to get from the
technicians)
Frequency Matching
(1)Whenthereceiverispoweredon,thegreenlightflashesquicklyaftershort-circuitingGNG and
MODE KEY. OpentheH12Tool on the remote controller, click Frequency Matching to start
matching. The green light of the receiver will be always on when the match issuccessful.
Quickly power on the receiver 5 times, and start the match mode for the 6th time, the green light
flashes. Open the H12Tool on the remote control, click Frequency Matching to start matching.
The green light of the receiver is always on after the match issuccessful.