Instructions

58
Note :
Before entering the values, check the position of the rotary switch and the type of probe used. The choice
of unit depends on this position (A/m, V/m, µW/cm²). Manipulation of the switch, or changing the probe,
exits the Fielfmeter from the program mode.
8.2 WRITING A NUMBER
After having chosen the function to program, the former value (a number of three hyphens) is displayed.
If three hyphens are displayed, simply press
▼
or
▼
to display the minimum value (0 for
the alarms, 1 mm for the clock, ∆t and SCAN).
Automatically, the digit on the right ashes: this is the active digit.
To increase the value of the active digit, keep
▼
pressed in. Likewise, to reduce the value, keep
▼
pressed in. Changing the active digit upwards (... 7, 8, 9, 0, 1, 2, ...) or downwards (..., 3, 2,
1, 0, 9, 8, 7, ...) automatically increases or decreases the gure(s) to the left of this. Release the button
when the required digit is shown.
If during the operation increasing or decreasing the digit, the maximum or minimum capacity of the display
is exceeded, three hyphens again appear.
The
▼
and
▼
buttons allow you to move the active digit (ashing) that you want to program
respectively to the left, or to the right.
When the digit furthest to the left is active, press
▼
to display three hyphens and the previously
displayed value disappears. Idem for the
▼
button when the active digit is located on the far right
of the display.
Note :
The increase of the digit on the left gives access to tens by carrying the remainder. The validation of «- - -»
allows you to block the current programming which will no longer appear on the display in measurement
mode. To do this, simply return to measurement mode by pressing
PRGM
when these symbols are
displayed.
8.3 SPECIAL CASE OF µW/cm²
The programming of alarms in the case of µW/cm² measurements is distinguished by the possibility of
suppressing or setting the decimal point (whole number or decimal number).
To suppress the decimal point, activate the digit on the right (see previous paragraph «Writing a number»)
press
▼
again to suppress the decimal point.
To set the decimal point (only one decimal possible), activate the digit on the left then press
▼
again. The decimal point appears again.