Instructions

54
Automatic memorisation mode is stopped by pressing MIN MAX for more than two seconds. During
memorisation, if the rotary switch or the measurement probe are handled, the function is also stopped.
Notes :
The MIN, MAX and AVG values accessible in measurement mode for reading with the MIN MAX button
are not memorised. In fact, these values do not correspond to the time chosen, but to the total operating
time of the recording mode since the rst press on MIN MAX ∆t (see in MEASUREMENT MODE, min,
max and average recording).
6.3 READ MEASUREMENT MEMORY
Set the rotary switch to MR to read the different values in the memory (MR is displayed on the screen).
Automatically, the last memorisation appears, by date.
The colon (:) at the middle of the time display is continuously visible to show that the time displayed is
not the current time. (time and date).
For each memorisation (each memory address), the different symbols remind the user of all the parameters
of the measurement at the time of the memorisation.
Press MEM at any time to display the number of the memory address of the screen display.
You may :
- either, read all the contents of the measurement memory by scrolling the different
memorisations by means of the
▼
and
▼
buttons;
- or, read only the memorisations that have triggered an alarm by pressing ALARM beforehand.
▼
On read memory mode, the PEAK button changes to its second function as indicated by the
 symbol printed on the case.
This second function allows you to decrease the different addresses of the measurement
memory, each press moves back the read address by one.
If the read address contains a manual memorisation, the display will indicate all parameters
present at the time of memorisation. MEM (Time, SMOOTH Filter or PEAK and Unit, but not
the alarms, even if they were selected, not the state of the alarms).
If the read function is done by automatic memorisation (∆t programmed), each wave of
memorisation occupies threee consecutive addresses for the values AVG, MAX and MIN.
These three values are available by successive decreases:
The rst address that si read contains the parameters of the AVG value (the time display
contains the duration of ∆t programmed). Press
▼
to display the parameters of the
MAX measurement (the clock shows the time at which this maximum occured).
The third address read whilst decreasing contains the parameters of the MIN measurement
(the clock gives the time when this minimum occured).