User Manual

Applications
58
4.10. ScopeNet IV
When you have obtained the IP address of the ScopiX
(DHCP or manual) using a browser, type
14.3.250.51/scopenet.html (for example) on your
computer  this opens the screen shown opposite.
 JAVA application PC is used to display the
ScopeNet IV page.
Carefully check the installation of ScopeNet to
forestall any difficulties.
To check the instruments connected, follow the
procedure:

Press the network icon, in the centre of the screen:
the search for instruments in the network (Ethernet
and WiFi) is effected by a specific function. A series
of compatible instruments connected is displayed:
see opposite.

The PC environment uses icons in an HMI identical
to the Scopix IV product, with the same access to
the functions and adjustments.
In "Oscilloscope" mode, ScopeNet IV proposes
adjustments by a right click on the waveform:
RUN/STOP, AUTO/TRIG/SINGLE/AUTOSET and
ZOOM are easy-to-configure parameters.
 Example: 2 active channels: CH1 and CH4
2 greyed-out inactive channels: CH2 and CH3
In MULTIMETER mode, the vertical configuration can
be accessed by a click in the window shown opposite:

activation of the channel

the AUTO RANGE mode, as default:
manual adjustment from among a set of ranges
(white zone around the quantity)

the coupling (shown opposite)
 Example: - channel 1 active, AUTO
- channels 2 and 3 inactive, AUTO
- channel 4 inactive, but adjustment of the
voltage ranges is possible.
File and backup management are active on the PC, but
it is possible, via USB, to store in ScopiX .