Brochure

ACCESSORIES
PROBIX
ACCESSORIES
The accessories
The “plug and play” accessories
are recognized automatically
when they are connected. This
means they can be implemented
quickly and in total safety. It is also
possible to connect BNC accessories and standard
banana leads with the safety adapters supplied.
Interchangeable coloured collars can be used to link
each accessory to the colour of its channel.
The sensors are powered and calibrated via the
oscilloscope.
Some accessories even include three control buttons
directly accessible on the probe to optimize your settings
without any bother.
Identification of the accessories and
management of safety
Once they have been hooked up, the probes and adapters
are identified by the oscilloscope which retrieves their
characteristics. Active safety is built-in, notably in the form
of safety information and recommendations concerning
the accessory used. All the accessories are powered
directly from the oscilloscope.
Configuration of the channels and
management of the sensors
The sensors’ coefficients, scales and units are managed
automatically, as is the configuration of the channels.
Control buttons on the probes can be used to modify the
settings of the channel to which they are connected. They
also offer the functions accessible on the oscilloscope’s
front panel.
Probix functions:
X voltage measurements
• by probe with different bandwidths and attenuation
• by BNC or banana connections
X current measurements
• by AC or AC/DC clamp
• directly: banana connections
X temperature measurements
• by K thermocouple sensor
• by Pt100 sensor
Replacement accessories
HX0030B: Probix probe, 600 V CAT III
HX0034B: Probix clamp with round cable, 80A AC/DC 500 kHz
HX0179: µSD card (8 GB)
HX0080: 1 USB/µSD adapter + USB adapter
P01102155: PA40W battery charger-power pack-2 LI-ION batt.
HX0120: METRIX bag for SCOPIX IV
HX0121: set of 5 screen styluses for SCOPIX IV
HX0122: transport strap for SCOPIX IV