User Manual

7
2.1.2. DISPLAY FUNCTIONS
 Display of waveforms (voltages and currents).
 Display of frequency bar chart (voltages and currents) (excluding neutral current).
 Screen captures (12 maximum).
 Transients function (for the C.A. 8333 only). Detection and recording of transients (up to 51) between user-defined start and
stop dates and times. Recording of 4 complete cycles (one before the triggering event and three after) in the 6 acquisition
channels.
 Trend recording (data logging) function. 2GB memory with date-stamping and user-defined start and stop dates for record-
ing, with a maximum of 100 recordings. Display, in bar chart or curve form, of the means of many parameters vs. time, with
or without minima and maxima.
 Alarm function (for the C.A. 8333 only). List of recorded alarms (up to 4,662) exceeding thresholds defined in the configuration
menu. User-defined alarm monitoring start and stop times – not more than two monitoring operations
2.1.3. CONFIGURATION FUNCTIONS
 Date and time setting.
 Screen brightness setting.
 Choice of curve colours.
 Choice of management of switching off of the screen.
 Choice of display in night mode.
 Choice of calculation methods (non-active quantities broken down or not, choice of the coefficients of calculation of the K
factor, choice of reference for the level of harmonics (for the C.A. 8333 only).
 Choice of distribution system (single-phase, two-phase, three-phase with or without neutral) and of the connection method
(standard method or 2-element method).
 Configuration of recording, alarms (for the C.A. 8333 only) and transients.
 Erasure of data (total or partial).
 Display of software and hardware version numbers.
 Choice of language.
 Display of current sensors detected not detected, not managed, simulated or impossible to simulate (2-element connection
method and 4-wire three-phase connection) . Setting of voltage and current ratio, of the transduction ratios and of the sensitivity.