User Manual

53
9.3. VIEWING THE RECORDING LIST
The submenu displays the recording list already made.
Recording list memory usage. The
black part of the bar corresponds to
the fraction of memory used.
Recording name.
Recording start time.
Recording stop time.
Figure 77: Recording list display screen
If the stop date is in red, it means that it does not match the stop date initially programmed, because of a power supply problem
(battery low or disconnection of the device supplied by mains only).
9.4. DELETING RECORDINGS
When the list of records is displayed (see figure 77), select the recording to be erased. This is done by moving the cursor to it
using the  and  keys. The selected recording is bolded.
Then press the key. Press

to validate or to cancel.
9.5. VIEWING THE RECORDS
9.5.1. CHARACTERISTICS OF THE RECORD
When the list of records is displayed (see figure 77), select the record to be displayed. This is done by moving the cursor to it
using the  and  keys. The selected recording is bolded. Then press

to validate.
Figure 78: Recording list display screen
If a measurement does not appear in the tabs, it is because calculation of this measurement was incompatible with the configura-
tion chosen (connection, types of sensors, ratios programmed).
For example, if the calculation mode chosen during the programming is Non-active Quantities not broken down (see §4.5.1), the
D tab does not appear.
Press a yellow key to display the curve.
Types of measurement chosen in the
configuration used.
The icon is used to navigate in
the following screen pages. It is also
possible to use the  or  key.