User Manual

33
Note: The curves to be displayed selection filter is dynamic and depends on the connection chosen. For example, it proposes
(3U, 3A) for a 3-wire three-phase set-up
To return to the Transient list screen, press .
5.3. DELETING A SEARCH FOR TRANSIENTS
When the list of searches for transients is displayed (see figure 39), select the search to be erased. This is done by moving the
cursor to it using the  and  keys. The selected search is bolded.
Then press the key. Press

to validate or to cancel.
Note: A search for transients can be deleted only if it is not in progress.
5.4. DELETE A TRANSIENT
When the list of transients in a search is displayed (see figure 40), select the transient to be erased. This is done by moving the
cursor to it using the  and  keys. The selected transient is bolded.
Then press the key. Press

to validate or to cancel.
To return to the List of Searches, press the key.