User Manual

27
Figure 30: The Voltage thresholds screen in the Transient Mode menu
To change the current thresholds, press

.
Use the arrow keys (,) to choose configuration of the thresholds.
 3A: all current sensors have the same threshold.
 Press the

key, then use the , keys to highlight the value of the threshold in yellow.
 Press the

key, then use the ,, and  keys to change the threshold. The unit can be the A, the kA or the mA.
 A1+A2+A3: each current sensor has a different threshold, to be programmed.
Proceed as when there is only one ratio, but perform the operation several times.
Validate with the

key. To return to the Configuration menu, press .
Note: Changing the thresholds in the transient mode is impossible if the device is searching for transients.
4.9. TREND MODE
The device has a recording function ( key, see §9), used to record measured and calculated values (Urms, Vrms, Arms, etc.).
Press the key of the Configuration mode and select the Trend Mode sub-menu.
Figure 31: The first screen of the Trend mode Figure 32: The second screen of the Trend mode
There are 4 possible programmable configurations , , and independent of one another. To go from one to the
other, use the or key.
To select the parameter to be recorded, move the yellow cursor to this parameter using the ,, and  keys then validate with
the

key. The selected parameter is identified by a red spot. The frequency (Hz) is always selected (black spot).
Note: If a quantity is displayed in red, it means that it is incompatible with the configuration chosen (connection selected, sensors
connected, ratios programmed, reference of the level of harmonics of the phases, breakdown of the non-active quantities).
For example, if no current sensor is connected, all current quantities will be in red.
To select all of the parameters of a page, press the key.
To unselect all of the parameters of a page, press the key.