User Manual

14
3. USE
3.1. START-UP
To switch the device on, press the button. It lights when pressed, then goes off if the mains power unit is not connected to
the device.
After the software check, the home page is displayed, then the information screen that indicates the software version of the
device and its serial number.
Figure 7: Home page at start-up
Then the Waveform screen is displayed.
Figure 8: Waveform screen
3.2. CONFIGURATION
To configure the device, proceed as follows:
 Press . The configuration screen appears.
 Press  or  to select the parameter to be modified. Press  to enter the selected sub-menu.
Figure 9: Configuration screen
Then use the arrow keys ( or  and  or ) and the  key to validate. For more details, see §§4.3 to 4.10.
For the C.A 8333 only