User Manual

105
 Turn the device over and hold the battery as it slides out of its compartment.
 Disconnect the battery connector without pulling on the wires.
Note: The Qualistar+ preserves the date-time function for approximately 4 hours without the battery.
The Qualistar+ preserves an inrush current capture for approximately 2 hours without its battery.
Spent batteries must not be treated as ordinary household waste. Take them to the appropriate recycling collection point.
Fitting the new battery.
 Connect the new battery. The connector is error-proofed to prevent reversals of polarity.
 Place the battery in its compartment and arrange the wires so that they do not protrude.
 Put the battery compartment cover back in place and screw the 2 quarter-turn screws back in.
Warning: If the battery is disconnected, it must then be fully recharged, even if it is not replaced, so that the device will know the
battery charge condition (this information is lost when the battery is disconnected).
17.4. REPLACING THE SCREEN FILM
Proceed as follows to replace the screen film of the device:
 Remove the old screen film.
 Remove the protection plastic film from the new screen film using the white tab.
 Place the adhesive side of the film against the screen of the device. Smooth the film with a clean cloth to remove any air bubbles.