User Manual

28
6.3.7. Changing the frequency of reading of a Bluetooth peripheral
From the peripherals manager (above), it is possible to change the reading period of the selected peripheral:
the Right arrow is used to start the entry of a new reading period. The period is displayed on a blue ground with the symbol
indicating that the Up/Down arrows can now be used to change its value. The F2 key is then used to validate the entry, while
the F3 key or the Left arrow cancels it. The reading period can be set to 50 minutes.
6.3.8. Displaying the measurements of the various Bluetooth peripherals
Once the peripherals are connected to the camera, it is possible to view all measurements read from the
Main/Parameters/Bluetooth menu, by validating the item opposite.
Attention! To maintain consistency between the Bluetooth measurements and the image displayed, the measurements
are refreshed in the measurements manager at each new acquisition. If acquisition is stopped (the image is
frozen), there is no update of the measurements manager. Watch out in particular when you connect
peripherals while the image is frozen: the measurements from these peripherals will not appear in the
measurements manager until the next acquisition.
This menu is used to list all Bluetooth measurements
recovered on the peripherals connected to the camera during
the last acquisition. When a measurement is selected
(Up/Down arrows), the right-hand part identifies the peripheral
that makes the measurement, an image indicates the type of
measurement (here, a temperature), and finally the use made
of this measurement (use indicated by the symbol in front of
the measurement in the list).
The possible
types of
measurement are
temperature measurement in °C or °F
current measurement in Amperes
power measurement in Watts
voltage measurement in Volts
frequency measurement in Hertz
impedance measurement in Ohms
capacitance measurement in Farads
relative humidity measurement in %
target distance measurement in feet or in metres
other measurement
Several uses are
possible
hidden
The measurement does not appear among the Bluetooth measurements displayed at the
bottom of the main screen.
displayed The measurement is added to the list of Bluetooth measurements displayed at the bottom
of the main screen (unless the Profile cursor is selected)
influence
The measurement is added to the list of measurements displayed at the bottom of the
main screen and can be used in the correction for the influencing factors or isotherm
cursor (see § 6.3.9. Using a Bluetooth measurement as an influencing parameter
).
Name of the
peripheral making the
me
asurement
Use made of the measurement
Type of measurement