User manual

Operating Instructions
ST-200X User Manual 10
Revision: 2004-11-02/11:00
ADDRESSING SLAVE UNITS
To make the most of the 4 and 8-light show programs, it will be necessary to address the units
according to the table illustrated below. The process for addressing slave units is the same as DMX
addressing.
1) Press the MENU button until the display reads {Addr}.
2) Press the ENTER button to select DMX addressing. Once selected the display will read either a
1 or any other number that may have previously been set. You must make a selection within 6
seconds.
3) Press the UP and DOWN buttons to increase or decrease values until the desired value is
achieved.
4) Press the ENTER button to activate selection.
Table 2 - 4-Light Show Addressing
4-Pattern
Show
Activity Fixture Address {Addr}
SH-0
SH-1
SH-2
SH-3
SH-4
SH-5
SH-6
SH-7
SH-8
SH-9
SH-A
SH-B
1234 Full On
1-2-3-4
4-3-2-1
1-2-3-4-3-2
12-34
24-13
23-14
1-12-123-1234-123-12-1-stop
4-43-432-4321-432-43-4-stop
1-2-1-2-3-4-3-4
4-1-4-1-2-3-2-3
3-1-3-1-2-4-2-4
Master = 001
Slave 1 = 003
Slave 2 = 005
Slave 3 = 007
Table 3 - 8-Light Show Addressing
8-Pattern
Show
Activity Fixture Address {Addr}
SH-0
SH-1
SH-2
SH-3
SH-4
SH-5
SH-6
SH-7
SH-8
SH-9
SH-A
SH-B
12345678 Full On
1-2-3-4-5-6-7-8
8-7-6-5-4-3-2-1
81-72-63-54-63-72-81
15-26-37-48
84-73-62-51
1357-2468
1234-5678
1256-3478
12-23-34-45-56-67-78-81
87-76-65-54-43-32-21-18
54-63-72-81
Master = 001
Slave 1 = 003
Slave 2 = 005
Slave 3 = 007
Slave 4 = 009
Slave 5 = 011
Slave 6 = 013
Slave 7 = 015
Segment Display Configurations {IdSP}
The display can be inverted making it easier to read the menu depending on the orientation of your
fixture.
DISPLAY INVERSE {IdSP}
1) Tap the MENU button until the display reads {IdSP}.