User manual

Page 4 of 26 Scorpion™ Scan RGB EU User Manual (Rev. 01c)
Safety Notes
Please read the following notes carefully because they include important safety
information about the installation, usage, and maintenance of this product.
• Keep this User Manual for future consultation. If you sell this product to another
user, be sure that they also receive this document.
• Always make sure that the voltage of the outlet to which you are connecting this
product is within the range stated on the decal or rear panel of the fixture.
• This product is for indoor use only! To prevent risk of fire or shock, do not expose
this fixture to rain or moisture.
• Make sure there are no flammable materials close to the unit while operating.
• Always install this product in a location with adequate ventilation, at least 20 in (50
cm) from adjacent surfaces. Be sure that no ventilation slots are blocked.
• Always disconnect this product from the power source before cleaning it or
replacing fuse.
• Make sure to replace the fuse with another of the same type and rating.
• If mounting it overhead, always secure this product to a fastening device using a
safety chain.
• The maximum ambient temperature (Ta) is 104° F (40° C). Do not operate this
product at higher temperatures.
• In the event of a serious operating problem, stop using the unit immediately.
Never try to repair the unit. Repairs carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest authorized technical
assistance center.
• Never connect this product to a dimmer pack.
• Make sure the power cord is not crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Never carry a fixture from the power cord or any moving part. Always use the
hanging/mounting bracket or the handles.
• Always avoid direct eye exposure to the light source when this fixture is on.
• Lasers can be hazardous and have unique safety considerations. Permanent eye
injury and blindness is possible if lasers are used incorrectly. Pay close attention
to each safety REMARK and WARNING statement in this user manual. Read all
instructions carefully BEFORE operating this device.
• Avoid direct eye contact with laser light. Never intentionally expose your eyes or
others to direct laser light.
• This laser product can potentially cause instant eye injury or blindness if laser light
directly strikes the eyes.
• It is illegal and dangerous to shine this laser into audience areas, where the
audience or other personnel could get direct laser beams or bright reflections into
their eyes.
• Never shine any laser at aircraft.
• Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
• There are no user serviceable parts inside the unit. Do not open the housing or
attempt any repairs yourself. In the unlikely event that your unit may require
service, please contact the dealer nearest to you.
Non-interlocked Housing Warning
• This unit contains high power laser devices internally.
• This unit will not turn off automatically or stay off if you open its housing (non-
interlocked housing).
• Do not operate the laser with if the housing is open due to potential exposure to
unsafe levels of laser radiation.
• The laser power levels, accessible if the unit is open when in operation, can cause
instant blindness, skin burns, and fires.