User manual

Scorpion™ RGB Scan EU User Manual (Rev. 01c) Page 15 of 26
DMX
Operating
Mode
Setting this product to operate in DMX mode will allow you to control it with a DMX
controller.
1) Connect this product to a suitable power outlet.
2) Turn this product on.
3) Connect a DMX cable from the DMX output of the DMX controller to the DMX
input socket of this product.
Starting
Address
When selecting a starting DMX address, you must always consider the number of
DMX channels assigned to the selected DMX mode. If you choose a starting address
that is too high, you could restrict the access to some of the channels of the DMX
mode in use.
The Scorpion™ Scan RGB EU uses seventeen (17) DMX channels, which defines
the highest configurable address to 496.
If you are not familiar with the DMX protocol, you may refer to the “DMX Primer”
section in the “Technical Information” chapter.
To select the starting address, do the following:
1) Press <MENU> repeatedly until the current starting address (001 to 496) shows
blinking on the display.
2) Use <UP> or <DOWN> to select a different starting address (001~496).
3) Press <ENTER> (the new starting address will show solid on the display).