User manual

Scorpion™ RGB Scan EU User Manual (Rev. 01c) Page 13 of 26
4.
O
PERATION
Control
Panel
Operation
To access the control panel functions, use the four buttons located underneath the
display.
Button Function
<MENU>
Press to find an operation mode or
to back out of the current menu
option
<DOWN>
Press to scroll down the list of
options or to find a lower value
<UP>
Press to scroll up the list of options
or to find a higher value
<ENTER>
Press to activate a menu option or a
selected value
Menu
Branches
The menu structure of the Scorpion™ Scan RGB EU has five branches.
The structure of the menu branches is as follows:
• Auto/Sound: 4 options
• Sound Sensitivity: 10 options
• DMX address: 512 options
• Slave: 1 option
• Reverse: 4 options
• The control panel will remember the last setting you programmed, even
after you have turned the fixture off.
• In addition, the control panel will remember the last selected option from
each menu branch.
Changing
Options
(Current Menu
Branch)
To change an option within the same menu branch, do the following:
1) Press <MENU> once (the LED display will blink).
2) Press <UP> or <DOWN> until the desired menu option shows on the LED
display.
3) Press <ENTER> to accept the new option (the new option will show solid on the
LED display).
Changing
Options
(Different
Menu Branch)
To change an option on a different menu branch, you must exit the current branch.
1) Press <MENU> once (the LED display will blink).
2) Press <MENU> repeatedly until seeing the active option of the desired menu
branch.
3) Press <UP> or <DOWN> until the desired menu option within the new menu
branch shows on the LED display.
4) Press <ENTER> to accept the new option (the new option will show solid on the
LED display).