User manual

Typical MVP™ Installation
16- MVP™ Ta8 Curve User Manual, Rev. 1
7. Typical MVP™ Installation
Because a video wall system can include different components to provide a simple to complex modular wall design, use
the following steps as a general guide to get started.
Step 1
Open and examine the MVP™ Ta8 Curve flight case to make sure you have received all
products and accessories and that each one is in good condition.
Step 2
Apply power and run the self-test for each MVP™ Ta8 Curve to ensure all LEDs and inside
connections in each panel are working (optional).
Step 3
Create a stable mounting surface (i.e., truss or other stable surface) for MVP™ Ta8 Curve
mounting.
Step 4
Mount the top row of the MVP™ Ta8 Curves first. Refer to the Mounting section in this User
Manual.
Step 5
Adjust the alignment of the first row using the speego connectors.
Step 6
Connect the signal source to the VIP™ Driver. Connect the VIP™ Driver to the VIP™ Signal
Distributor (if applicable).
Step 7
Connect either VIP™ Driver or VIP™ Signal Distributor (if being used) to the Input Signal
socket of the first panel in your connection chain.
Step 8
Based on your video wall configuration (design), join each panel, either horizontally or
vertically, using the instructions in the section, Joining Each MVP™
(Creating a Modular
Design).
Refer to the instructions and information in the section of this User Manual, Connecting
(Cabling) Each MVP™.