User manual

Connecting (Cabling) Each MVP™
12- MVP™ Ta8 Curve User Manual, Rev. 1
Connecting the
Signal Input
The VIP™ video wall system uses 2 basic setup configurations to connect the signal to
the video wall:
1. A configuration using 24 or less panels.
2. A configuration using more than 24 panels.
The next section, Connecting Power and Signal Cables
, gives information on connecting
power and signal between joined panels and to the rest of the VIP™ system.
The following configuration of 24 panels shows a direct connection from the signal to the
VIP™ Driv
er into the first panel’s Signal Input socket. Refer to the VIP™ Driver Quick
Reference Guide for information and instructions on the VIP™ Driver.
The VIP™ system’s maximum signal load is 24 or less panels on a single signal
cable connection. When using more than 24 panels in a video wall design, you will
need a VIP™ Signal Distributor and additional signal cables to accommodate the
number of panels
over 24. A VIP™ Signal Distributor output supports up to 8
signal output lines, providing up to 192 total panels that can be connected from
the VIP™ Signal Distributor. You also can add more VIP™ Signal Distributors to a
VIP™ video wall system. Refer to th
e VIP™ Signal Distributor Quick Reference
Guide for more information.
Pixel limitation may limit to less than 192 panels.
VIP™ Driver
DVI-D
Backup
connection from
the last MVP™ in
the series
Single MVP™
(panel)
Signal Socket