User manual

Introduction
LED Studio User Manual Rev. 2 -5-
3. Setup
Connecting the
Hardware
(MVP™ Driver)
The LED Studio software works with the CHAUVET® MVP™ Driver. You may connect
up to four MVP™ Drivers, each outputting up to 1280 x 1024 total video wall resolution.
Connecting a single
MVP™ Driver
The MVP™ Driver uses the USB connection for all of the addressing and other
communication to the device. You run the video separately through the DVI
or HDMI
connection.
1. Make sure the product power switch is OFF
2. Plug in the USB to the driver
3. Plug in the DVI/HDMI video source to the driver
4. Set the DIP switch address to [Sender #1]
5. Connect from the output of U, D, or both, depending on the desired configuration
The Signal LED indicator relates to the DVI video input source, not the USB
connection.
The panel quantity limitation for each of the U and D outputs is 24 panels (daisy-
chained). For more panels, an MVP™ Signal Distributor is required.
HDMI Video Input
DVI Video Input
USB Data
connection
Linking Serial Input
(
used only for more than
1 Driver)
Linking Serial Output
(used only for more than 1
Driver)
Linking DIP
switches
Computer running LED Studio
Video Source
(May be connected to computer output)
MVP™ Driver
USB Cable
DVI Cable