User manual

Introduction
LED Studio User Manual Rev. 2 -3-
Product Overview (Setup Hardware Parameters Window)
Title Description
1
MVP™ Driver output port Select the output port for the selected panel
2
Extension port/cable Select the output of the MVP™ Signal Distributor
3
Order number Select the order number from either the MVP™ Driver or the MVP™ Signal
Distributor
4
Panel width
Select the individual panel pixel width. This may be found in the panel user manual
5
Panel height Select the individual panel pixel height. This may be found in the panel user
manual
6
Save to receiver Once the “Save to receiver” function is successful this is used to save the
configuration in the panels. This will remain even after cycling the panel power
on/off.
7
Send to receiver Once the entire configuration is complete, this is used as a temporary addressing
test (not permanent). After you visually confirm that the addressing is correct, use
the “Save to receiver” function
8
Save to file Save the configuration file to a backup file
9
Panel blue intensity Modify the individual panel maximum blue intensity
10
Load from file Load a saved configuration file
11
Panel green intensity Modify the individual panel maximum green intensity
12
Save card for maintenance Save the individual panel settings for later maintenance
13
Panel red intensity Modify the individual panel maximum red intensity
Click to Select Panel
6+7
8
9
10
11
5
4
3
2
1
12
13