User manual

Customizing

LED Studio User Manual Rev. 2 -17-

5. Customizing

Screen Area

When you are using multiple displays, each display is addressed overlapping on the top,

left corner of the screen.

This section describes how to change the position of the

different displays in LED Studio, so that you have independent control over them.

Complete the panel addressing before you perform this procedure.

1. Select Option > Screen Area

2. Select the display you wish to move

3. Change the values of the <Start X> and/or <Start Y> until the displays are not

overlapping

4. Press the <Save to screen> Button. The settings are now saved to the video wall

A red box will show around the perimeter of each display. If this box is not

showing correctly, then you may need to readdress the video wall.

One of the displays may remain in the top, left corner of the screen. This is a Start

X and Y of 0, 0.

You may also use the “nudge” controls to virtually

move the displays by single

digits.

Select <Screen Area>