User manual

Addressing
-12- LED Studio User Manual Rev. 2
8. Once each panel has been addressed, press <Send to receiver> to test the
configuration on the panels (the panels must be connected)
9. A window will appear to confirm if the setting was sent successfully. Select <YES>,
to move onto the next step. Select
<NO>
to edit the last saved setting.
10. If your settings are correct and the panels address properly, then continue to save
the configuration in the panels by pressing the
<Save to receiver>
button.
Standard Block Layout
(Quick Address)
There is an option that is only available for the Standard Block layout. This is called the
“Quick Address” option. Access this by using the following drop-down menu.
Please refer to Standard Block Layout (Full Address) for
screen shots of
steps 1–6.
1. Open LED Studio
2. Select Options > Hardware Setting
3. Select the <Display connection> tab
4. Select the width and height of your screen (in panel quantity)
5. Click on the top, left panel to highlight its settings
6. Select the top, left panel and set the following parameters:
a. Width (different for each model panel; found in the panel’s specifications)
b. Height (different for each model panel; found in the panel’s specifications)
c. MVP™ Driver output
d. Extension port/cable port (if not using an MVP™ Signal Distributor,
set this to “1”)
e. Order number (corresponds to the order of the panel in the daisy-chain)
Send to
receiver
Button