User manual

Addressing

LED Studio User Manual Rev. 2 -11-

MVP™ Driver

(back)

6. Set each of the following parameters of each panel:

a. Width (different for each model panel; found in the panel’s specifications)

b. Height (different for each model panel; found in the panel’s specifications)

c. The MVP™ Driver output refers to the etherCON® connection used for the

signal (U and D)

d. The Extension port/cable port refers to which output you are using on the

MVP™ Signal Distributor (if not using a MVP™ Signal Distributor, set this to “1”)

e. Order number (corresponds to the order of the panel in the daisy-chain, see

)

MVP™ Signal Distributor

(back)

7. Set the DIP switch to assign the address, from 1 through 4

When not using the MVP™ Signal Distributor, you should set the value of

the

Extention cable port to 1.

This is the first physical panel connected by the signal cable (etherCON®) from the

MVP™ Driver.

Panel Height

Panel Width

Order Number

Extension c

able

ort

MVP Driver

Output

MVP

™ Driver

Addressing

(DIP

switches 1

-4)

MVP™

Driver Output

(U and D)

Extension

Port 1–4

Extension

Port 5–8