User manual

Introduction
LED Studio User Manual Rev. 2 -7-
Installing the USB
Hardware Drivers
The hardware drivers must be installed before the LED Studio software can
communicate with the MVP™ Driver.
1. Plug the USB cable into the Windows-based computer
2. Plug in the IEC power cable and turn on the power switch
3. The Windows machine should automatically prompt you to install the hardware
drivers. The current passcode is: 9291115
4. If you have not already installed LED Studio, open the application installation file
that is located on the software disk that ships with the MVP™ Driver and follow the
software installation steps
5. The software creates a subfolder in the LED Studio program folder directory. This
folder is //Program files/LED Studio/CP210x
6. For 32-bit systems, use the //Program files/LED Studio/CP210x/x86 folder
7. For 64-bit systems, use the //Program files/LED Studio/CP210x/x64 folder
8. If you open the LED Studio software and see the following window, then the
hardware drivers have not been installed properly
Troubleshooting
If you do not have the hardware drivers properly installed, the window below will appear.
Try reinstalling the drivers as described in Installing the USB hardware drivers.
The driver installation utility will automatically install the drivers for 32-
bit
operating systems only! 64-bit operating systems require manual
driver
installation through the device manager in your Windows software.
Error Window