User manual

Introduction

-6- LED Studio User Manual Rev. 2

Connecting Multiple

MVP™ Drivers

The LED Studio software is capable of controlling up to four MVP™ Drivers

simultaneously, a feature good for a

larger video wall setup, or when a unique video

source for each MVP™ Driver is required.

1. Make sure the product power switch is OFF

2. Plug in the USB to the driver

3. Plug in the DVI/HDMI video source to the driver

4. Set the DIP switch address to [Sender #1]

5. Connect from the output of U, D, or both, depending on the desired configuration

Computer running LED Studio

Video Source

(May be connected to

computer output)

MVP™ Driver

USB Cable

DVI Cable

MVP™ Driver

DVI Cable

9-pin serial Cable

DVI Cable