User manual

Appendix
LEG-3000 Manual 19 Revision: 2006-01-20/16:03
10
000  255
Tilt
Down (0°) > Up (270°) (128 = half way point)
11
000  255
Pan (Fine)
12
000  255
Tilt (Fine)
13
000  007
008  063
064  127
128  255
Control
Pan/Tilt Tracking Mode
Pan/Tilt Vector Mode: Slow > Fast
Reserved
Mechanical reset after 3 seconds
14
000  047
048  095
096  159
160  207
208  255
Lamp ON/OFF
Standby
Hold 3 seconds for Lamp ON
Standby
Hold 3 seconds for Lamp OFF
Standby
8 Bit Movement
In the 8 bit Pan/Tilt resolution setting both (FINE) channels is removed. All other channel parameters
remain the same as in the “DMX Channel Values” table.
CHANNEL FUNCTION
1 Dimmer
2 Shutter
3 Color
4 Static Gobo
5 Rotating Gobo
6 Gobo Rotation
7 Prism
8 Focus
9 Pan
10 Tilt
11 Control
12 Lamp ON/OFF
Dip Switches (settings explained)
DIP SWITCH EVENT NOTES
All Off
The lamp will strike first. If striking of the lamp succeeds, in
approximately 15 seconds the fixture’s motors will be powered
and initialized. If the lamp does not strike, the remainder of the
fixture will not initialize and you will not have control of the
fixture. Please wait 15 minutes before re-starting the
fixture, otherwise perform a service check.
This is the default
setting on the fixture
and helps in reducing
the amount of striking or
inrush current used by
the fixture upon startup.
1-On Lamp and motors are powered at the same time.
Will consume the most
amount of inrush current
in the startup phase.
2-On Only the lamp will turn on in the fixture.
1-On, 2-On Only the lamp will turn on in the fixture
3-On This switch will terminate the dmx connection.
Use only at the end of a
DMX daisy chain.