User manual

Appendix
LEG-3000 Manual 16 Revision: 2006-01-20/16:03
Self Demonstration & Master/Slave
{    } – Self-demo
This function will execute the built-in program in the fixture.
FUNCTION SET TO NOTES
Off Normal


On Run self-demonstration
{    } – Demo speed
You can set the pace of the demo to either quick or fast.
FUNCTION SET TO NOTES
Off Quick paced


On Slow paced
{     } – Sound-Active (Master/Slave)
In this mode the fixture can be set to run in a sound-activated mode in either a fast or slow pace.
Additionally, slave fixtures can all also be set to synchronize to the first fixture or in this case Master.
Please disconnect from the controller before enabling this function.
Requirements:
In the Legend 3000X the default 16-bit channel mode is required to be set. The Legend 3000X is
controlled using 14 channels.
FUNCTION SET TO NOTES
Off Normal “Off”


On
Sound-active slow pace
FUNCTION SET TO NOTES
Off Normal “Off”


On
Sound-active fast pace
Master Fixture Settings
1. DMX address Ch 001
2. Set Aud.S or Aud.F to “On”
Slave Fixture Settings
In a Master/Slave setup all slave fixtures following the master would be addressed the same. Please
follow the following instructions for all slave fixtures.
Legend 2000X: DMX address Ch 014, Aud.S or Aud.F set to OFF
Legend 3000X: DMX address Ch 015, Aud.S or Aud.F set to OFF
Important!
All Slave fixtures must have “Aud.S” or “Aud.F” set to off.
You must set “Aud.S” and “Aud.F” to off to regain DMX control of the fixture.