User manual
Table Of Contents
- 1. Before You Begin
- 2. Introduction
- 3. Interfaces
- 4. Setting up the Hardware/Software
- Minimum Hardware Requirements (without 3D visualization)
- Minimum Hardware Requirements (with 3d visualization)
- Software Installation (Windows® XP, Vista & 7)
- Hardware Driver Installation (Windows® Vista & 7)
- Driver Installation (Windows® XP)
- Driver Installation (Mac OSX)
- Driver Reinstallation (Windows® Vista & 7)
- Driver Reinstallation (Windows® XP)
- Interface Troubleshooting
- 5. Overview
- 6. Programming
- 7. Playback
- Importing Scenes into the Live-Buttons Screen
- Scene Playback Modifications
- Live-Buttons Page Playback Modifications
- Live-Button screen Playback
- 3D View
- Live-Timeline Screen
- 8. Upload Screen
- 9. Backup/Restore
- 10. Keyboard Shortcuts
- 11. Xpress™ 512-Plus Standalone Triggering
- 12. Updating the Interface Firmware
- 13. Appendix
- 14. Technical Specifications
11.
X
PRESS
™
512-P
LUS
S
TANDALONE
T
RIGGERING
56 Chauvet® ShowXpress™ V6.22
11. XPRESS™ 512-PLUS
STANDALONE TRIGGERING
Mini-DIN Triggering
The Xpress™ 512-Plus interface features wired triggering of up to 4 scenes in standalone operation.
These are accessed through the Mini-DIN connector on the interface.
A Ground-Fault Interrupt system is used for the triggering. Please see the wiring configuration
below.
Pin-1: Scene 1
Pin-2: Scene 2
Pin-3: Scene 3
Pin-4: Scene 4
Pin-5: Not Used
Pin-6: Ground
All buttons are push-button type, normal open.
This method will only trigger the first 4 scenes that are loaded into the interface.
Wiring Diagram