User manual
Table Of Contents
- 1. Before You Begin
- 2. Introduction
- 3. Interfaces
- 4. Setting up the Hardware/Software
- Minimum Hardware Requirements (without 3D visualization)
- Minimum Hardware Requirements (with 3d visualization)
- Software Installation (Windows® XP, Vista & 7)
- Hardware Driver Installation (Windows® Vista & 7)
- Driver Installation (Windows® XP)
- Driver Installation (Mac OSX)
- Driver Reinstallation (Windows® Vista & 7)
- Driver Reinstallation (Windows® XP)
- Interface Troubleshooting
- 5. Overview
- 6. Programming
- 7. Playback
- Importing Scenes into the Live-Buttons Screen
- Scene Playback Modifications
- Live-Buttons Page Playback Modifications
- Live-Button screen Playback
- 3D View
- Live-Timeline Screen
- 8. Upload Screen
- 9. Backup/Restore
- 10. Keyboard Shortcuts
- 11. Xpress™ 512-Plus Standalone Triggering
- 12. Updating the Interface Firmware
- 13. Appendix
- 14. Technical Specifications
7. Playback 45 Chauvet® ShowXpress™ V6.22
Fixture Settings Sub-screen
The following parameters are available for fixture modification within the 3D View Screen: Position,
Orientation, Scale, and Color. Please see the steps below for accessing these settings.
4. Open the 3D View
5. Right-click anywhere within the 3D View to bring up the menu.
6. Select “Fixtures settings”.
7. The window will open.
8. Select a fixture form the “Fixture Selection Area”. It will be highlighted in the 3D View
Screen so that it is possible to see the results of any change in settings immediately.
9. Select an attribute to modify from the Attribute Selection Area.
10. Use the “Value Setting Area” to adjust the setting(s). This may be done by entering the
value in directly with the keyboard or by using the mouse to manipulate the scroll tool.
Value
Setting
Area
Fixture
selection area
Undo
button
Attribute
Selection
Area
Enter Values
Directly
Scroll tool