User manual
Table Of Contents
- 1. Before You Begin
- 2. Introduction
- 3. Interfaces
- 4. Setting up the Hardware/Software
- Minimum Hardware Requirements (without 3D visualization)
- Minimum Hardware Requirements (with 3d visualization)
- Software Installation (Windows® XP, Vista & 7)
- Hardware Driver Installation (Windows® Vista & 7)
- Driver Installation (Windows® XP)
- Driver Installation (Mac OSX)
- Driver Reinstallation (Windows® Vista & 7)
- Driver Reinstallation (Windows® XP)
- Interface Troubleshooting
- 5. Overview
- 6. Programming
- 7. Playback
- Importing Scenes into the Live-Buttons Screen
- Scene Playback Modifications
- Live-Buttons Page Playback Modifications
- Live-Button screen Playback
- 3D View
- Live-Timeline Screen
- 8. Upload Screen
- 9. Backup/Restore
- 10. Keyboard Shortcuts
- 11. Xpress™ 512-Plus Standalone Triggering
- 12. Updating the Interface Firmware
- 13. Appendix
- 14. Technical Specifications
7. Playback 41 Chauvet® ShowXpress™ V6.22
Manual BPM
This is used for the playback speed of the scenes to synchronize with the audio BPM.
Please see the steps below to access this setting.
1. Open Live-buttons from the Control Board.
2. Right-click on the scene button and select “Speed button”.
3. In the window that appears, select “Manual BPM”.
4. Press <Validate>.
5. See the diagram below for instructions on assigning the value for the Manual
BPM..
This is a MANUAL setting, which will NOT synchronize with an external source.
BPM effects the time to switch to the next step in a scene
Available BPM: 10~500
Manual Speed
This mode refers to the manual adjustment in the speed of a program. This may be set
between 25% and 400%.
Please see the steps below to access this setting.
6. Open Live-buttons from the Control Board.
7. Right-click on the scene button and select “Speed button”.
8. In the window that appears, select “Manual Speed”.
9. Using the slide-bar, press & hold to drag to the desired speed value.
10. Press <Validate>.
Manual Setting
(using numbers on keyboard)
Visual Indicator
Manual Setting
(Press 3 times)