User manual

6. Programming 25 Chauvet® ShowXpress™ V6.22
3D View Area
To set the parameters of the 3D View for this fixture (LED PAR 64-Tri), see the following instructions.
1. In the drop down bar, select this fixture as a color changer.
2. Drag the lamp selection to 60W led.
The brighter the LED wattage is here, the brighter the fixture will appear in the 3D_View Screen.
3. Adjust the beam angle to 22°, to match the fixture (see the fixture specifications).
4. This fixture is now complete. Save the fixture.
DMX Patching
In order to view a fixture in the Editor screen, you must first add it to the DMX Patch in the Setup
screen. Please see the instructions below to add the LED PAR 64-Tri to the DMX Patch.
1. Switch the page tab in the Setup screen from fixtures setting to dmx addressing.
2. Right-click on the LED PAR 64-Tri to highlight it and bring up the option “Add fixture to the
dmx list”. Click on this option.
3. The “DMX addressing setting” sub-menu will appear. Let’s start this fixture off at DMX
address 001. We will set the clone to 4. This will also be on universe 1. It is also necessary
to set a name for this fixture. Using this name, we may recognize the fixture easily in the
Editor screen during programming.
4. Press <Save>. The fixture is now added to the DMX Patch.
5. Repeat this process to add more fixtures.
If there is a fixture that is not already in the “fixtures setting” page tab, then you may add more by using
the “import fixture” function.
Fixture T
yp
e
Lam
p
Selection Ba
r
Reverse Pan
Pan Maximum Angle
Tilt Maximum Angle
Reverse Tilt
Beam An
g
le
Reverse Dimme
r
Reverse Iris