User manual
Table Of Contents
- 1. Before You Begin
- 2. Introduction
- 3. Interfaces
- 4. Setting up the Hardware/Software
- Minimum Hardware Requirements (without 3D visualization)
- Minimum Hardware Requirements (with 3d visualization)
- Software Installation (Windows® XP, Vista & 7)
- Hardware Driver Installation (Windows® Vista & 7)
- Driver Installation (Windows® XP)
- Driver Installation (Mac OSX)
- Driver Reinstallation (Windows® Vista & 7)
- Driver Reinstallation (Windows® XP)
- Interface Troubleshooting
- 5. Overview
- 6. Programming
- 7. Playback
- Importing Scenes into the Live-Buttons Screen
- Scene Playback Modifications
- Live-Buttons Page Playback Modifications
- Live-Button screen Playback
- 3D View
- Live-Timeline Screen
- 8. Upload Screen
- 9. Backup/Restore
- 10. Keyboard Shortcuts
- 11. Xpress™ 512-Plus Standalone Triggering
- 12. Updating the Interface Firmware
- 13. Appendix
- 14. Technical Specifications
4. Setup 16 Chauvet® ShowXpress™ V6.22
3. Highlight the “BOX Interface (version x.xx)” (or “USB Plus interface, CABLE, REMOTE, or D512) and
select “uninstall” on the top menu bar. This will uninstall all associated drivers for the interface.
4. Click “scan for hardware changes” also on the top menu bar to have the computer auto-detect any
new hardware.
5. Repeat the same steps from “Hardware Installation (Windows® XP)” to install the driver again.
6. A popup balloon in the lower, right side of the monitor will indicate that the driver installation was
successful and the device is ready to use.