User Manual
TABLE OF CONTENTS 1. BEFORE YOU BEGIN............................................................................................................................................................ 3 WHAT IS INCLUDED ...................................................................................................................................................................... 3 UNPACKING INSTRUCTIONS ..........................................................................................................
1. BEFORE YOU BEGIN What is Included • • • • 1 x Comet™ LED 1 x Power Cord 1 x Warranty Card 1 x User Manual Unpacking Instructions Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damaged from shipping or the carton itself shows signs of mishandling. Save the carton and all packing materials.
Safety Instructions Please read these instructions carefully. It includes important information about the installation, usage and maintenance of this product. • • • • • • • • • • • • • • 1. Before You Begin Please keep this User Manual for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet.
2. INTRODUCTION Product Overview Back Panel Microphone Sensitivity Adjustment Knob Microphone Voltage Selection Switch (115/230 VAC) Fuseholder Power Out Power In 2.
3. SETUP AC Power This fixture is switchable and runs on 115 VAC, 60 Hz or 230 VAC, 50 Hz. Before powering on the unit, make sure the line voltage to which you are connecting it is within the range of accepted voltages that the voltage switch is set to. Modify the voltage switch selection if necessary. To determine the power requirements for a particular fixture, see the label affixed to the back plate of the fixture or refer to the fixture’s specifications chart.
Mounting Orientation The Comet™ LED may be mounted in any position, provided there is adequate room for ventilation. Rigging Be sure that the structure can support the weight of the fixture. Please see the “Technical Specifications” section of this manual for a detailed weight listing. Mount the fixture securely. This may be done with a screw, nut and bolt, or a hanging clamp. The hole in each bracket is 13 mm in size. When rigging consider routine maintenance and control panel access.
4. OPERATING INSTRUCTIONS Standalone Sound-Active This fixture has a preprogrammed, sound triggered chase. Adjust the microphone sensitivity from the control panel. No additional settings are required. 4.
5. APPENDIX General Troubleshooting SYMPTOM POSSIBLE CAUSE(S) • Excessive circuit load Breaker/Fuse keeps blowing Device does not power up • Short circuit along the power wires • No power • Loose power cord POSSIBLE ACTION(S) • Check total load placed on the electrical circuit. • Check for a short in the electrical wiring (internal and/or external). • Check for power on Mains. • Check power cord If you still have a problem after trying the above solutions, please contact CHAUVET® Technical Support.
TECHNICAL SPECIFICATIONS WEIGHT & DIMENSIONS Length ..............................................................................................................10.5 in (268 mm) Width ..................................................................................................................7.4 in (188 mm) Height ....................................................................................................................9 in (228 mm) Weight .....................................................
