User manual

Technical Support
Address: Service Dept.
3000 N 29th Ct, Hollywood, FL 33020 (U.S.A.)
Support (Email): [e-mail]
Telephone: [phone] - (
Fax: [phone] - (Attentio
Website: http://
5. APPENDIX
here nels may be as d in y mann
fixture capable of receiving DMX 512 will require one or a number of sequential channels. The user
a in the controller.
There and they all may vary in the total number
of cha els should
never erratic operation of the fixtures se starting address is
set incor e type using the same starting
addre or ope n. In other words, the
fixture
DMX f al Daisy Chain. isy Chain connection is
where e nex The order in hich
e fix ow a controller communicates to
f direct cabling. Connect fixtures
using XLR male to female connectors. The
shield pin 2 is Data Negative (S-) and pin 3 is Data positive (S+). CHAUVET
carrie pliant cables, DMX-10 (33’), DMX-4.5 (15’) and DMX (5’)
Press 4)
n: Service)
www.chauvetlighting.com
DMX Primer
T are 512 channels in a DMX-512 connection. Chan signe an er. A
must ssign a starting address on the fixture that indicates the first channel reserved
are many different types of DMX controllable fixtures
nnels required. Choosing a start address should be planned in advance. Chann
overlap. If they do, this will result in
who
rectly. You can however, control multiple fixtures of the sam
ss as long as the intended result is that of unison movement
s will be slaved together and all respond exactly the same.
ratio
ixtures are designed to receive data through a seri
cts to the DATA IN of th
A Da
t fixture.
the DATA OUT of one fixture conne w
th
each
tures are connected is not important and has no effect on h
ixture. Use an order that provides for the easiest and most
shielded two conductor twisted pair cable with three pin
connection is pin 1, while
s 3-pin XLR DMX com -1.5
Arena Hazer User Manual 14 2007-05-29/16:06