User manual

Page 4 of 16 Arena™ Hazer 3 User Manual (Rev. 01d)
Product at a Glance
Use on Dimmer
x
Auto Programs
x
Outdoor Use
x
Auto-ranging Power Supply
x
Sound Activated
x
Replaceable Fuse
P
DMX
P
User Serviceable
x
Master/Slave
x
Duty Cycle
x
Safety Notes
Please read the following notes carefully because they include important safety
information about the installation, usage, and maintenance of this product.
• Keep this User Manual for future consultation. If you sell this product to another
user, be sure that they also receive this document.
• Always make sure that the voltage of the outlet to which you are connecting this
product is within the range stated on the decal or rear panel of the fixture.
• This product is for indoor use only! To prevent risk of fire or shock, do not expose
this fixture to rain or moisture.
• Make sure there are no flammable materials close to the unit while operating.
• Always install this product in a location with adequate ventilation, at least 20 in (50
cm) from adjacent surfaces.
• Be sure that no ventilation slots on the unit’s housing are blocked.
• Always disconnect this product from the power source before cleaning it or
replacing fuse.
• Make sure to replace the fuse with another of the same type and rating.
• The maximum ambient temperature (Ta) is 104° F (40° C). Do not operate this
product at higher temperatures.
• In the event of a serious operating problem, stop using the unit immediately.
• Never try to repair this product. Repairs carried out by unskilled people can lead
to damage or malfunction. Please contact the nearest authorized technical
assistance center.
• Never connect this product to a dimmer pack.
• Make sure the power cord is not crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Never carry a fixture from the power cord or any moving part. Always use the
hanging/mounting bracket or the handles.
• Always avoid direct eye exposure to the light source when this fixture is on.
• Do not touch the output nozzle on this product. It is very hot during operation and
it may remain hot for several hours after turning the unit off.
• Do not mount this product on a flammable surface (e.g., wood, linoleum, carton,
plastic, or carpet).
• Make sure there are no flammable materials close to the unit while operating.
• Depending on the amount of fog/haze generated, all fog machines may set off
smoke detectors.