User's Manual

Page 17 of 22
WELL Panel User Manual Rev. 2
Operation
Line Voltage Power Loss Mode
This option sets the action that the fixture will during a line power loss.
1. Go to the Line Voltage Power Loss Mode main level.
2. Select among Stay in State (the fixture will continue to function as programmed under battery
power), All at Full (all LEDs will go to full power after 5 seconds of line power loss, and returns to
normal operation when line power is restored), and Dim Out (all LEDs will dim in a 10 second fade
to black and returns to normal operation when line power is restored).
Run Time
This option sets the fixture’s intensity and adjusts its battery run time.
1. Go to the Run Time main level.
2. Select among 3 Hours, 5 Hours, 8 Hours (reduces intensity, limiting battery run time to 3, 5, or
8 hours) and 12 Hours (extends battery to the maximum run time of 12 hours)
Back Light
This setting allows for selection of the amount of time the back light on the WELL Panel’s display stays on
after the last button is pressed on the control panel.
1. Go to the Back Light main level.
2. Select On (remains on), 10S (10 seconds), 20S (20 seconds), or 30S (seconds).
System Information
This option displays the total number of hours the product has run, the installed software version, and the
product’s UID.
1. Go to the Information main level.
2. Select Fixture Hours, Version, or UID.
Factory Reset
This option restores the WELL Panel to factory default settings.
1. Go to the Reset Factory main level.
2. Select No or Yes.
Master/Slave
The Master/Slave mode allows a group of WELL Panel products (the slaves) to simultaneously duplicate
the output of another WELL Panel (the master) without a DMX controller. To set each of the slaves:
1. Go to the Master/Slave main level.
2. Select Slave.
3. Go to Wireless Setting > W-DMX On/Off.
4. Select On.
5. Go to Wireless Setting > Operating Mode.
6. Select Receive.
7. Go to Wireless Setting > Receive Reset.
8. Select Yes.
To set the master:
1. Go to the Master/Slave main level.
2. Select Master.
3. Go to Wireless Setting > W-DMX On/Off.
4. Select On.
5. Go to Wireless Setting > Operating Mode.
6. Select Transmit.
7. Go to Wireless Setting > Link.
8. Select Link to link to the slave products.
9. Select a standalone setting, or control with the IR remote.
• The master is the one that runs a program whether in Auto, Static, or IR mode.
• Do not connect a DMX controller to the products configured for Master/Slave operation.
The DMX controller may interfere with signals from the master.
• Do not connect a WDMX transmitter to the products configured for Master/Slave
operation. The WDMX transmitter may interfere with signals from the master.