User's Manual

Page 10 of 22
Operation
WELL Panel User Manual Rev. 2
LED
Frequency
600Hz
Sets the PWM frequency
1200Hz
2000Hz
4000Hz
6000Hz
25KHz
Wireless
Setting
Receive On/Off
On
Enables/disables wireless DMX
Off
Receive Reset
No
Resets wireless receiver
Yes
Line Voltage
Power Loss
Mode
Stay In State
If line power is lost, the fixture will continue to
function as programmed under battery power
(default)
All At Full
After 5 seconds of line power loss, all LEDs will go to
full power (returns to normal operation when line
power is restored)
Dim Out
After 5 seconds of line power loss, the LEDs will
dim in a 10 second fade to black (returns to normal
operation when line power is restored)
Run Time
Off
Maximum intensity for all LEDs
3 Hours
Reduced intensity, limiting battery run time to
3 hours
5 Hours
Reduced intensity, limiting battery run time to
5 hours
8 Hours
Reduced intensity, limiting battery run time to
8 hours
12 Hours
Extends battery to the maximum run time of
12 hours
Back Light
10S
Turns off display backlight after 10 seconds of
inactivity
30S
Turns off display backlight after 30 seconds of
inactivity
2Min
Turns off display backlight after 2 minutes of
inactivity
Always On Display backlight always on
Key Lock
On
Locks display (password is <UP>, <DOWN>,
<UP>, <DOWN>, <ENTER>)
Off
Information
Fixture
Hours
<_ _ _ _H>
Shows total hours the product has been powered on
Version <V_._> Shows current firmware version
UID <_ _ _ _ _ _> Shows product UID
Factory Reset
No
Resets the product to factory default settings
Yes
Main Level Programming Levels Description