User Manual

Page 16 of 21
Operation
Rogue Outcast 3 Spot User Manual Rev. 1
USB Update
To enable or disable software update using USB:
1. Go to the Setup main level.
2. Select the USB Update option.
3. Select NO (disables software update through USB) or YES (enables software update through
USB).
Reset Function
To reset specific functions or the entire product:
1. Go to the Setup main level.
2. Select the Reset Function option.
3. Select the functions to reset, from Pan/Tilt, Prism, Color/Iris, Gobo/Gobo2, Frost, or All.
4. Select NO (to cancel) or YES (to reset the selected functions).
Factory Reset
To reset the product to factory settings:
1. Go to the Setup main level.
2. Select the Factory Set option.
3. Select NO (to cancel) or YES (to reset the product configuration).
Test Mode
Auto Test
To have the Rogue Outcast 3 Spot automatically test all functions one after the other:
1. Go to the Run Mode main level.
2. Select the Auto Test option.
Manual Test
To manually test an individual function of the Rogue Outcast 3 Spot:
1. Go to the Run Mode main level.
2. Select the Manual Test option.
3. Select a function to test, from Pan, Pan Fine, Tilt, Tilt Fine, P/T Speed, Dimmer, Dimmer Fine,
Shutter, Virtual Shaking, Color1, Color2, Gobo2, Gobo, Gobo Rotate, Gobo Index, Gobo2,
Focus, Focus Fine, Auto Focus, Zoom, Zoom Fine, Prism, Prism Rotate, Iris, Frost, or
Special Function.
4. Increase or decrease the value of the selected function from 000–255 to test it.
System Information
The information section of the menu displays statistics and the current status of the product’s various
functions. To view this information:
1. Go to the Sys Info main level.
2. Use <UP> and <DOWN> to view all information.
Offset Mode (Zero Adjust)
The Offset mode provides fine adjustments for the home position of the pan, tilt, and zoom movements. To
adjust these options:
1. From the main level screen, press and hold <MENU> until the passcode screen appears.
2. Use <UP> (increase value) and <DOWN> (next value) to enter the passcode: 2323 and press
<ENTER>.
3. Select the “zero” position to adjust, from PAN, TILT, COLOR1, COLOR2, GOBO, GOBO
ROTATE, GOBO2, FOCUS–GOBO, FOCUS–GOBO2, ZOOM, PRISM, IRIS, FROST, Light
Block, DIMMER1, DIMMER2, RDM4, RDM5, or RDM6.
4. Adjust the “zero” position for the selected function from 000–255.
See the
USB Software Update
section for the detailed instructions on how to update the
Rogue Outcast 3 Spot software using a USB C connection.