User Manual

Page 10 of 21
Operation
Rogue Outcast 3 Spot User Manual Rev. 1
Configuration (DMX)
Use control configurations to operate the product with a DMX controller.
Control Personalities
To set the control personality:
1. Go to the Run Mode main level.
2. Select the DMX option.
3. Select the desired personality from 20CH or 25CH.
Starting Address
Each product will respond to a unique starting address from the controller. All products with the same
starting address will respond in unison. To set the starting address:
1. Go to the Address main level.
2. Select the starting address (001–512).
• The highest recommended starting address for 20CH is 493.
• The highest recommended starting address for 25CH is 48.
Control Channel Assignments and Values
Sys Info
Ver V_._ _ _ _ _ _ Shows firmware version
Running Mode _ _ _ Shows current running mode
Dmx Address _ _ _ Shows current DMX address
Temperature _ _ _
Shows the product temperature
in °C
Fixture Hours _ _ _ _ _ Shows time product has been on
LED Hours _ _ _ _ _ Shows time LED has been on
UID _ _ _ _ _ _ _ _ _ _ _ _ Shows UID information
_Fan_ _ _ _ (x3) _ _ _ _ _ Shows speeds of fans
Base Fan1 _ _ _ _ _ Shows speed of base fan
•See the
Starting Address section for the highest starting address you can select for each
personality.
• Make sure that the starting addresses on the various products do not overlap due to the new
personality setting.
20CH 25CH Function Value Percent/Setting
11Pan 000  255 0–100%
2 2 Fine pan 000  255 Fine control (16-bit)
33Tilt 000  255 0–100%
4 4 Fine tilt 000  255 Fine control (16-bit)
5 5 Pan/tilt speed 000  255 Fast to slow
6 6 Dimmer 000  255 0–100%
– 7 Fine dimmer 000  255 Fine control (16-bit)
78Strobe
000  003 Off
004  007 On
008  076 Synchronized strobe, slow to fast
077  145 Pulse strobe, slow to fast
146  215 Random strobe, slow to fast
216  255 On
8 9 Virtual shaking
000  001 No function
002  128 Shaking effect, slow to fast
129  255 Fade effect, slow to fast
Main Level Programming Levels Description