User Manual

Intimidator™ Wave 360 IRC User Manual Rev. 2 Page 13 of 33
2-Fixture Program
The Master Auto 2-Head program allows a single Intimidator™ Wave 360 IRC
to control
the actions of another Intimidator™ Wave 360 IRC
. The master unit will be set to operate
in the M-2 program, while the slave unit will be set to operate in either Slave S-1 or
Slave
S-2 mode.
Configure the units as indicated below.
Master unit:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Mast Set.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to scroll to M-1, M-2, or M-4.
7. Press <ENTER>.
8. Use <UP> or <DOWN> to select M-2.
9. Press <ENTER>.
Slave unit:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Slave S-1, or Slave S-2.
• Select Slave S-1 for 100% synchronized actions with both fixtures in tandem.
• Select Slave S-2 for a delayed wave, up to 2 fixtures.
5. Press <ENTER>.
1-Fixture
Program
The Master Auto 1-Head program allows all heads of any amount of linked
Intimidator™
Wave 360 IRC
units to operate in unison. The master unit will be set to operate in the
M-1 program, while the slave units will be set to operate in Slave S-1 mode.
Configure the units as indicated below.
Master unit:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Mast Set.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to scroll to M-1, M-2, or M-4.
7. Press <ENTER>.
8. Use <UP> or <DOWN> to select M-1.
9. Press <ENTER>.
Slave unit:
1. Press <MENU> and use <UP> or <DOWN> to select Run Mode.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select Slave S-1.
4. Press <ENTER>.
5. Select Slave S-1.
6. Press <ENTER>.
• Configure all the slave units before connecting the master unit to the DMX
daisy chain.
•
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the
master unit.