User Manual

Page 12 of 33 Intimidator™ Wave 360 IRC User Manual Rev. 2
Master Auto
Programs
The Master Auto built-in programs control the actions of two or more
Intimidator™ Wave
360 IRC units linked together by DMX data connection. A single Intimidator™ Wave
360
IRC (the master) controls the actions of another Intimidator™ Wave 360 IRC (the slav
e).
Configure the Master Auto programs in conjunction with the Slave modes as follows:
4-Fixture
Program
The Master Auto 4-Head program allows all 4 heads of four linked Intimidator™ Wave
360
IRC
units to operate in unison. The master unit will be set to operate in the
M-4 program, while the slave unit will be set to operate in either Slave S-1, Slave S-2
,
Slave S-3, or Slave S-4 mode.
Configure the units as indicated below.
Master unit:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Mast Set.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to scroll to M-1, M-2, or M-4.
7. Press <ENTER>.
8. Use <UP> or <DOWN> to select M-4.
9. Press <ENTER>.
Slave unit:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Slave S-1, Slave S-2, Slave S-3, or Slave S-4.
5. Press <ENTER>.
6. Select Slave S-1 for 100% synchronized actions.
7. Select Slave S-2, S-3 or S-4 for a delayed show with up to 4 fixtures, for up to
16
heads total, in the same direction but with a delay creating a wave effect.
8. Press <ENTER>.