User Manual

Page 14 of 17 Intimidator Scan™ LED 300 User Manual Rev. 6
Changing
Gobos
To change the gobos in the Intimidator™ Scan 300, you do not need to remove the gobo
wheel. Simply:
1. Turn off and disconnect fixture from power outlet.
2. Place the product on a flat, level surface with the front facing up.
3. Open the head cover by loosening the ten fastening screws at the sides of the top
cover.
4. Remove the four screws on the cover plate underneath the display to access the
gobo wheel.
5. Rotate the gobo wheel until the gobo that needs replacing is accessible.
6. Separate the gobo holder away from the gobo wheel by pushing it forward, toward
the mirror/LED. Be careful not to push the gobo out of the gobo plate.
7. Extract the gobo holder by pulling it outward (straight up). (See the #1 & 2 arrows
on diagram.)
8. On a flat surface, remove the expansion ring that holds the gobo in place and
remove the gobo from the gobo plate.
9. Insert a new gobo and hold it in place with the expansion ring.
10. To re-insert the new gobos, slide the tip of the gobo holder under the pressure plate
near the center of the gobo wheel.
11. Push the gobo holder inwards. DO NOT force the gobo holder into the gobo wheel
slot. If correctly installed, the gobo holder should accommodate itself in the gobo
wheel slot.
12. Replace covers.
Gobo Replacement Diagram
Gobo Wheel Detail Views
Expansion Ring
Gobo
Gobo Holder