Manualshelf

User Manual

ManualsBrandsChauvet DJ ManualsMobile Heads and ScannersIntimidator Scan 305 IRC
11121314151617181920
Intimidator Scan/Barrel 305 IRC User Manual Rev. 1 Page 13 of 27
Configuration
(DMX)
To set the product in DMX mode for control with a DMX controller, do the following:
1. Make sure the product is plugged into a power source.
2. Connect the male end of a DMX cable to the DMX out socket of the DMX controller and
the female end of the same cable to the DMX in socket on the product.
3. Set the DMX starting address and personality by following the directions below.
DMX Starting
Address
When selecting a starting DMX address, always consider the number of DMX channels
needed for the selected DMX personality. Choosing a starting address that is too high can
restrict access to some of the product’s channels.
The Intimidator Scan/Barrel 305 IRC uses either 7 or 11
channels, depending on the
personality. The highest configurable DMX address in 7-channel mode is 506. The highest
configurable DMX address in 11-channel mode is 502.
For more information about DMX download the Chauvet DMX Primer from the Chauvet web
site http://www.chauvetlighting.com/download.
To set the DMX starting address, do the following:
1. If the display shows a number from 001–512, go to step 5.
2. Press <MENU> repeatedly until 4 icons show on the display.
3. Use <UP> or <DOWN> to highlight Address.
4. Press <ENTER> and a number from 001–512 will show on the display.
5. Use <UP> or <DOWN> to change the number to the desired DMX starting address.
6. Press <ENTER> to select the DMX starting address.
DMX Personalities
The Intimidator Scan/Barrel 305 IRC has 2 DMX personalities: a 7-channel personality and
an 11-channel personality.
To set the DMX personality, do the following:
1. Press <MENU> repeatedly until 4 icons show on the display.
2. Use <UP> or <DOWN> to highlight the Run Mode icon.
3. Press <ENTER> and the Run Mode options will show on the display.
4. Use <UP> or <DOWN> to highlight DMX.
5. Press <ENTER>. A green dot will show on the DMX option line and the characters 7CH
or 11CH will show in green.
6. Use <UP> or <DOWN> to switch between 7CH and 11CH.
7. Press
<ENTER>
to select the DMX personality shown.
After the DMX starting address and personality have been set, there will be a delay of
30 seconds before the display automatically returns
to showing the current DMX
address and the DMX personality.