User's Guide

④ Velcro speaker disks, foam microphone-covers, microphone Velcro
sticker
⑤ Helmet Mounting bracket with Cradle, 2 Screws and Allen Wrench
⑥ Manual and ChatterBox logo sticker
(3) Battery Charging
Connect the supplied USB cable into a PC or wall Charger.
(4) Battery
This product has an irreplaceable rechargeable battery inside. Therefore,
when using the product, make sure to adhere to the following:
⚫ Never separate the battery from the product as this may damage
the product
⚫ The battery performance may be reduced over time with usage
⚫ In recharging the battery, make sure to use an approved charger
provided by the manufacture. Use of a non-approved charger may
cause fire, explosion, leakage, and other hazards may also reduce
the life time or performance of the battery.
⚫ Do not use cigarette chargers other than the included cigarette
charger to charge the unit.
⚫ Store the battery at the temperatures of -20°C ~+50°C / -
4°F~+122°F. Higher or lower temperatures may reduce the capacity
and life of the battery or may cause temporary non-operation.
⚫ Do not use the product in sub-zero temperature, because it may
cause serious reduction of the battery performance.
⚫ If you apply heat to the battery or throw it into fire, it may explode.
⚫ Do not use the product with a damaged battery. It may explode
and/or cause accidents.
⚫ Battery life may vary depending on conditions, environmental
factors, functions of the product in use, and devices used with it.
2. INSTALLATION
(1) HEADSET AND MICROPHONE
① The Headset comes with both with open and full face microphones.
Please choose the one that you intend to use and plug it in the
connector on the cradle.
② For full face helmet, attach soft Velcro disk to the helmet chin bar and
attach hard Velcro disk to the microphones.
③ Apply the soft Velcro disks on the liner of your helmet. Mound them in
the indentation of the helmet padding where your ears would line up.