BiT-4 USER’S MANUAL ChatterBox UNIMO Technology Co.,Ltd.
CONTENTS 1. GETTING STARTED Main features Package contents Battery charging Battery 2. INSTALLATION Installation of Speaker and Microphone Installation of cradle, bracket and BiT-4 main device 3. BUTTONS AND PORT 4. BASIC FUNCTIONS Power on / off Volume up / down Automatic power off Voice command 5. SMART-PHONE CONNECTION Smart-phone pairing Second Smart-phone pairing New Smart-phone (the third Smart-phone) replacement 6.
Universal Intercom mode 4 Riders Multi-Intercom mode Surround Monitoring mode Battery power level 7. PHONE FUNCTION Answering incoming call Rejecting incoming call Hanging up the call Automatic answering Holding the current call, answering an incoming call While in calling, rejecting another incoming call Last number redialing & Speed dial While being on the phone, switching device between BiT-4 and Smart-phone 8.
10. INTERCOM MODE Volume control in Intercom mode 1:1 Intercom pairing 1:1 Intercom connection / disconnection Audio Multi-Tasking 4 Riders Multi-Intercom pairing 4 Riders Multi-Intercom connection / disconnection 4 Riders Multi-Intercom reconnection and reposition 1:1 Intercom automatic re-connection 11.
14. RESET Reset Factory Reset 15. SMART-PHONE APPLICATION CONTROL 16. SOFTWARE UPGRADE 17. SUPPORT Precaution Limited warranty Limitation of liability Reasons for limited liabilities Disclaimer of liability Customer service center 18. FAQ (Frequently Asked Questions) 19. CE/FCC DECLARATION 20. SIMPLE MANUAL 1. GETTING STARTED Thank you for choosing our ChatterBox BiT-4, Bluetooth Communication System for Motorcycle helmet. Main features Bluetooth V 4.
Universal Intercom FM Radio 5 Languages voice prompt (English, French, German, Italian, Spanish) Dual pairing with two Bluetooth devices (Smart-phone, MP3, Navigation etc) Music sharing Surround monitoring Audio Multi-tasking Answering phone call using VOX Side Tone (Listening own voice during phone conversation) Smart-phone Application Control Usable during charging Volume of each mode is separately adjustable during Intercom communication Allowing Interco
Battery charging Connect the supplied USB charging data cable with a PC or wall charger. Be sure to charge the product using the USB charging data cable provided. Charge with a normal charger of 5V or less than 1.2A. Using a high-speed charger for Smart-phones or a supplementary battery with high-speed charging (9V, higher than 1.2A) may inflate the battery, cause an explosion, or damage internal circuits. With a normal charger, it takes 2.5~3 hours to fully charge. Charging time depends on the temperature.
cause reduced battery capacity, battery life, or temporary inactivity. Long exposure of the product to direct sunlight in a hot temperature may cause circuit failure or battery failure. Do not use any product damaged by impact, circuit or battery failure may occur. 2. INSTALLATION Speaker and Microphone Installation Both microphones for open-face and full-face helmets are provided. Please choose the one that you intend to use for the type of your helmet.
※ CAUTION: Repositioning of the Velcro stickers of the speakers and microphones more than one time may result in poor adhesion. ( Velcro stickers are available on the website, http://www.chatterboxglobal.com/) Open-Face microphone Ultra Slim Full-face microphone Speakers Cradle and Bracket Installation of cradle, bracket and BiT-4 main device 1. Prepare the provided cradle, bracket, screws and L-wrench. 2.
3. BUTTONS AND PORT 4. BASIC FUNCTIONS Power On/Off: Long press POWER BUTTON for 3 seconds. Volume Up: Press the PLUS BUTTON with intervals of longer than 0.5 seconds. Volume Down: Press the MINUS BUTTON with intervals of longer than 0.5 seconds. ※ CAUTION: Fast double-pressing within 0.5 seconds will result in searching next / previous song in Music mode OR that will result in scanning up and down channels in FM radio mode.
recognition function of your Smart-phone is activated. 5. SMART-PHONE CONNECTION Smart-phone Pairing ① Make sure your BiT-4 device is powered off. ② Press and hold POWER BUTTON for 8 seconds until the LED turns and flashes in Red and Blue alternately.
Short double-press the FUNCTION BUTTON. FM radio Mode: Short double-press FUNCTION BUTTON. 1:1 Intercom Mode: (Rider & Passenger Intercom) To connect Intercom: Short press POWER BUTTON. To disconnect Intercom: Short press POWER BUTTON again. ※ Intercom Pairing must be preceded Universal Intercom Mode : To connect Intercom: Short double-press POWER BUTTON. To disconnect Intercom: Short double-press POWER BUTTON again.
‘4’ = 80~100% ‘3’ = 60~80% ‘2’ = 40~60% ‘1’ = 20~40% ‘Low Battery’ = 0~20% 7. PHONE FUNCTIONS Answering an incoming call: Press the FUNCTION BUTTON shorter than 1 second. Rejecting an incoming call: Press the FUNCTION BUTTON longer than 1 second. Hanging up the call: Press the FUNCTION BUTTON longer than 1 second. Automatic answering: If you take no action for an incoming call for 20 seconds, device will answer automatically. (This function can be adjusted by Smart-phone Application Control.
If you want to take off your helmet in the middle of phone conversation and you want to talk on your Smart-phone directly, press and hold the PLUS and MINUS BUTTONs simultaneously for longer than 1 second, then the call switch over from BiT-4 to your Smart-phone. In order to switch over back to BiT-4, do the same operation. 8. MUSIC MODE Enter / Exit music mode: Short double-press the FUNCTION BUTTON. [Voice Prompt: “Music play mode”] Music Play / Stop: Short press FUNCTION BUTTON.
Music Sharing disconnection: Simultaneously press PLUS and FUNCTION BUTTON until you hear a Beep sound. Music Sharing reconnection: Simultaneously press PLUS and FUNCTION BUTTON until you hear a Beep sound. ※ If BiT-4 is paired with two Smart Smart-phones, s, you can not use the Music Sharing function. 9. FM RADIO MODE double-press FUNCTION BUTTON. [Voice Prompt: “FM radio Enter / Exit FM radio mode : Short double Mode”] Play / Mute FM radio : Short press FUNCTION BUTTON once.
1:1 Intercom Pairing ① Place two devices to pair close to each other. ② Long press INTERCOM BUTTONs of both devices for 3 seconds until the LED flashes in red and blue alternately. [Voice Prompt: “Pairing”] ③ Short press INTERCOM BUTTON of the device to be set as a Master. [Voice Prompt: “Intercom Pairing”] Then, Red LED flashes fast to enter pairing mode. ④ As pairing is completed, the Green LED flashes.
⑤ The second and the third device will be paired in the same pairing procedure. Each device can have only one Master and one Slave. ※ As your device is already connected with one device, in case that you wish to pair with another device, press INTERCOM BUTTON for 6 seconds. After the Multi-Intercom pairing is completed, each device will be given a number among 1 to 4. Your number and the others’ number can be notified by press the CRADLE BUTTON. Check your given number:: Short press the CRADLE BUTTON.
Audio Multi-Tasking Audio Multi-Tasking allows the 4 Riders Multi-Intercom can maintain the Intercom communication without being interrupted ted by a phone call, Music or FM radio sound. Briefly, you can listen to Music, FM radio,, and can make a Phone call while keeping the Intercom communication. communication ※ Each volume of Intercom conversation, phone call, music sound, or FM radio can separately adjustable.
1:1 Intercom Automatic Re--connection If 1:1 Intercom conversation is disconnected by a distance or poor signal, your device will search for the previously paired device to reconnect for 2 minutes. ※ While being connected in the Multi-Intercom pairing, your device can also be connected with 1:1 Intercom OR Universal Intercom connection. But, Maximum 4 devices or less should be connected. 11.
① Place two devices to pair close to each other. ② Long press INTERCOM BUTTON for 3 seconds until the Red and Blue LEDs flash alternately. [Voice Prompt: Pairing] ③ Double press INTERCOM BUTTON of BiT-4. [Voice Prompt: “Group Pairing”] Then, Blue LED flashes fast to enter Universal pairing mode. ④ Now, BiT-4 is ready to be paired. Please refer to a user manual of Non-ChatterBox product to find out the method of universal pairing.
12. SURROUND MONITORING MODE In case that you want to hear external sound without taking off your helmet, long-press the CRADLE BUTTON at the bottom of the cradle for 2 seconds. To exit, long press the CRADLE BUTTON for 2 seconds. 13. SET UP MODE After stopping Music or FM radio function, simultaneously press PLUS and MINUS BUTTON for the 3 seconds in order to enter the set up mode. [Voice Prompt: ”config”] To search the option through Set up menu, press PLUS or MINUS BUTTON.
(3) VOX SET UP VOX is a function to answer an incoming phone call by using loud voice or shouting without using any button. (As a phone rings, taking no action would lead to an automatic answer in 20 seconds) ① After hearing Voice prompt of “VOX”, short press the FUNCTION BUTTON to enter. [Voice Prompt: “VOX”]. ② Press the PLUS or MINUS BUTTON to search a VOX sensitivity you desire and then, short press the FUNCTION BUTTON to save.
Rebooting Reboot the device when the function stops working or if you cannot turn off the power of the device. To reboot the device, insert USB charging data cable while pressing and holding the MINUS (-) BUTTON. However, the pairing information, language setting, and saved FM radio channels will not be deleted. Factory default reset To initialize all settings and set the device back to the factory default setting, while holding FUNCTION BUTTON, press MINUS (-) BUTTON for 8 seconds.
Store or use the product at temperatures of -15°C ~ +50°C. Too high and too low temperatures may damage, shorten capacity and life of the battery, or may cause the product to be inoperative. Keep the product out of direct sunlight. Exposing the product to direct sunlight may damage the electrical circuit and battery. It is particularly dangerous to expose the product to direct sunlight in a closed vehicle in summer. Do not apply any physical impact to the device.
In case of returning via courier, the end-user must be able to return the defective product with its original package along with a copy of the original purchase receipt from the store where the purchase was made. The warranty service will be provided through the store where the first purchase was made. If you have difficulty contacting the store, please contact us at the provided contact information in this manual.
Liabilities disclaimer In addition to damages which may occur due to the use of the product, Chatterbox will not be liable for damages of the product which occur due to the following events. In the event the product is misused or used for purposes other than its intended purpose. In the event the product is damaged because the user does not follow the content of the product manual. In the event the product is damaged because it has been left unattended or has undergone any other accident.
Bluetooth products. Q: When I use Intercom, I feel more noise and disconnection toward a certain direction. A: Bluetooth ISM band is also a part of radio frequency. Radio frequency has very similar character to the light. Radio frequency cannot go through water, soil, rock, metal plate and human body. The human body consists of 70% water. Therefore, Bluetooth communication cannot be connected well through body. This phenomenon can happen when you have your Smart-phone in your back pocket.
Der vollständige Text der EU-Konformitätserklärung ist unter der folgenden Internetadresse support/library verfügbar: http://www.chatterboxglobal.com/us/board/list.php?bdId=morgueEU Bitte beachten Sie, dass dieses Produkt Radiofrequenzbänder benutzt, die innerhalb der EU nicht harmonisiert sind.
Pour plus d’informations, veuillez consulter notre site internet/support/library : http://www.chatterboxglobal.com/us/board/list.php?bdId=morgueEU Veuillez noter que ce produit utilise des bandes de radio fréquence non uniformisées au sein de l’Union Européenne.
Address: 11627 Telegraph Rd. Suite #103 Santa Fe Springs, CA蘮USA Website: www.chatterboxusa.com Customer service center in EUROPE Address: Talstrasse 39 D-77887-SASBACHWALDEN, GERMANY 20.
Voice Command (Smart-phone’s Siri function) While being on the phone, switching device between BiT-4 and Smart-phone After stopping Music or FM radio, press the PLUS BUTTON longer than 1 second While being on the phone, simultaneously press the PLUS and MINUS BUTTONs for 1.
Universal Intercom Short double-press the POWER BUTTON / connection /disconnection Short double-press the POWER BUTTON Multi-Intercom connection Short press the INTERCOM BUTTON or / disconnection Short double-press the INTERCOM BUTTON Intercom volume control Long press the PLUS or MINUS BUTTON Verify the given number of your device Short press the CRADLE BUTTON Verify the given number of the other device which is connected with yours Short double-press the CRADLE BUTTON
