TeraFrame™ HD Cabinet System Supplemental Installation Guide 800-834-4969 techsupport@chatsworth.com www.chatsworth.com ©2010 Chatsworth Products, Inc. All rights reserved. CPI, TeraFrame and MegaFrame are registered trademarks of Chatsworth Products, Inc. All other trademarks belong to their respective companies.
Chatsworth Products Inc. Installation Guide TeraFrame HD Installation Guide TeraFrame HD This guide provides additional recommendations for installing, transporting, and establishing a safe work environment for the TeraFrame™ HD cabinet system. It is intended to supplement The TeraFrame™ Cabinet System User’s Manual. 08/27/10 October 21 2009 Safe & Proper Use Statement LOAD RATING Static load rating: 3,000 lb (1364 Kg.) Dynamic load rating: 3,000 lb (1364 Kg.) Chatsworth Products Inc.
Chatsworth Products Inc. Installation Guide TeraFrame HD 08/27/10 CONVENTIONS USED IN THIS MANUAL This manual provides general safety guidelines to be observed when planning for, installing, and operating your TeraFrame HD cabinet. Special messages used throughout this manual are explained below: WARNING: Text highlighted in this manner indicates that failure to follow directions in the warning could result in bodily harm or loss of life.
Chatsworth Products Inc. Installation Guide TeraFrame HD 08/27/10 Recyclable materials CPI uses only recyclable materials in all of its cabinet packaging. Please save packaging for later use or dispose of properly. All wood components of CPI pallets have been properly treated to comply with the pest-free certifications required by foreign countries. Please Inspect for Shipping Damage before the carrier leaves your premise: Each TeraFrame cabinet leaves our plant in perfect condition.
Chatsworth Products Inc. Installation Guide TeraFrame HD 08/27/10 CAUTION: Position pallet loaded with cabinet to allow 20 feet of clearance between the pallet/ramp interface and final stopping point for cabinet to roll off ramp and come to a complete stop. 1. Check pallet deck height versus ramp. If pallet deck is too low to properly align with ramp, carefully lift pallet with appropriate equipment (pallet jack, forklift, etc.
Chatsworth Products Inc. Installation Guide TeraFrame HD 08/27/10 CAUTION: • • The engineered shock pallet is designed to only be used only once. The pallet should not be reused after the cabinet reaches its destination. Reusing a shock pallet may not protect the cabinet and installed equipment. If a cabinet with installed equipment needs to be shipped to a new destination, a new shock pallet must be used.
Chatsworth Products Inc. Installation Guide TeraFrame HD 08/27/10 Installing Equipment To ensure rack stability: • • • Load cabinet from the bottom up and load heavier components first. It is recommended to allow a minimum clearance of 30 in. (762 mm) at the back of the rack. It is recommended to allow a minimum of 48 in. (1219.2 mm) clearance beyond the front of the rack to permit server installation and removal.
Chatsworth Products Inc. Installation Guide TeraFrame HD 08/27/10 Disclaimer CPI disclaims any responsibility and shall be held harmless for any damages or losses incurred by the user in any of the following cases: 1. Fire, earthquake, or any other act of God; acts by third parties; misuse by the user, whether intentional or accidental; use under extreme operating conditions. 2.
