Specifications

Chassis Plans CPR-30201 KVM Technical Reference
Page 38
If you didn’t enable Check Firmware Version, the Utility installs the upgrade file
s without checking whether they are
a higher level, or not
. As the Upgrade proceeds status messages appear in the Status Messages panel, and
the progress toward completion is shown on the Progress bar.
Upgrade Successful
After the upgrade has completed, a screen appears to inform you that the procedure was successful.
To complete the upgrade:
1. Click Finish to close the Firmware Upgrade Utility.
2. Power off the switch by unplugging the KVM cable that you connected in step 6 of Before You Begin, from
the back of the switch.
3. Remove the Firmware Upgrade Cable.
4. Slide the Firmware Upgrade Switch to the Normal position.
5. Connect all the KVM cables.
6. If you are using a power adapter, plug its cable back in.
Upgrade Failed
If the Upgrade Successful screen doesn’t appear, it means that the upgrade failed to complete successfully, in
which case you should repeat the upgrade procedure from the beginning.