Specifications

Chassis Plans CPR-30201 KVM Technical Reference
Page 25
Before you Begin
1. Make sure that power to all the devices you will be connecting up have been turned off.
2. To prevent damage to your installation make sure that all devices on the installation are properly grounded.
Cable Connection
To set up your KVMS-RGBA4 installation, refer to the installation diagrams on the following pages, and do the
following:
1. Plug your monitor into the Console monitor port located on the unit’s rear panel.
2. Plug your microphone and speakers into the Console microphone and speaker jacks located on the unit’s
rear panel.
3. Using a KVM cable set (provided with this package), plug the custom SPDB connector into any available
CPU Port on the switch and plug the accompanying microphone and speaker cables into the CPU Port’s
microphone and speaker jacks.
Note: Be sure that all the plugs are in the same CPU Port sockets (all in Port 1, all in Port 2, etc.).
4. At the other end of the cable:
a) For a USB connection, plug the USB, video, microphone and speaker cables into their respective
ports on the computer.
b) For a PS/2 connection, plug the keyboard, mouse, video, microphone and speaker cables into their
respective ports on the computer. Repeat steps 4 and 5 for any other computers you are
connecting up.
5. Turn on the power to the computers.
Rear Panel Connections