Specifications

Chassis Plans CPR-30201 Technical Reference
Page 6
Rear Panel Signal Connectors
Cable Display End Cable Computer End - USB
The CPR-30201 provides a front panel Source selection button for selecting which input signal is to be displayed.
In addition, Picture-In-Picture is supported where the S-Video or Composite video inputs can be displayed as a
small window on top of the aRGB or DVI-D inputs.
An audio amplifier is provided with a computer input source and 2 RCA audio inputs for right and left channel. The
front of the display provides two speakers connected to the audio amplifier. The audio channel can be selected via
the OSD for the computer input or the RCA video input (PIP). There is no provision to output sound from one RCA
input source to both speakers.
The KVM provides switching only for the aRGB inputs. The DVI-D, Composite and S-Video inputs are connected
directly to the display.
Picture-In-Picture (PIP)
The CPR-30201 supports PIP. The PIP window can be sized to Small (approx 1.4x2.0”), Medium (2.9x4.0”) or
Large (4.3x5.6”). There are 5 preset PIP window positions or the window can be moved to a user selected position
through the OSD menus. The PIP window is used to put a smaller video feed window on top of a full computer
display. The PIP button on the front panel can be used to select the video feed to display and the size.
The PIP source can only be S-Video or Composite input on top of either aRGB or DVI-D. The display will not use
either the aRGB or DVI-D as a PIP source. Setting the primary input to either Composite or S-Video disables the
PIP function.
The PIP window turns off when the monitor enters sleep mode, is turned off with the front Power control or is
stowed flat into the rack. To re-establish the PIP window, press the PIP button on the front panel and select the
desired input source and size using the + or – buttons.
Note The default PIP source is TV. Whenever PIP is disabled by turning off the monitor or entering sleep
mode, the PIP input source will revert back to TV. After pressing PIP on the front panel, push either the
▲ or ▼ buttons to change to the PIP input selection Quick Menu and then + or ─ to change to the
desired input source.